Ако на някой му е интересно...
Настройване на LEE Load Master
Ще се радвам да чуя мнения на колеги ползващи тази прогресивна преса дали е така или не? Също ако имат нещо интересно да споделят, ще е полезно за всички.
Линк:
http://forums.loadmastervideos.com/foru ... ?f=2&t=699Съдържание:
I learned a lot of great tips on setting up the Load Master from users on this forum and used them to setup my press this weekend. Following is a summary:
Mount press to a sturdy workbench with 1/4" bolts
Smooth rough edges of case retainer under primer feed arm
Remove raised letters from bottom of primer depth adjustment screw
Remove any burs on primer feeding system
Lubricate and cycle the press several times after first lube to break in the press - do not apply grease to the bottom of the shell plate
ADJUST CASE RETAINERS
Remove turret
Move retainers in
Place empty case in station 1 and cycle the press
INSTALL TURRET
Apply blue LockTite on turret screw
Wiggle turret and tighten screw
INSTALL SIZING/DECAPPING DIE
Lower lever
Screw in until bottom of die contacts shell plate
Tighten lock nut
Raise lever
Screw die in additional 1/4 turn
INSTALL POWDER THROUGH/EXPANDING DIE
Lower lever
Screw in until bottom of die contacts shell plate
Unscrew die 3/4 turn and finger tighten lock nut
Turn screw in for additional flair
INSTALL BULLET SEATING DIE
Unscrew bullet seating screw to its outermost position
Open case retainer and place completed round in shell plate
Lower lever
Screw die until it makes firm contact
Finger tighten lock nut
Turn bullet seating screw until it touches the tip of the bullet
INSTALL FACTORY CRIMP DIE
Unscrew crimp die to its outermost position
Lower lever
Screw in until bottom of die contacts shell plate
Finger tighten lock nut
Open case retainer and place completed round in shell plate
Lower lever
Turn in adjusting screw until it just touches the case mouth
Lift lever
Screw in additional 1/2 turn for light crimp, one full turn for heavy crimp
ADJUST PRIMER DEPTH
Turn adjusting bolt to its most upward position
Insert case with spent primer in station 1, advance to station 2
Lower handle, turn bolt down to lever
Raise lever
Turn bolt downward two additional bolt faces
Tighten lock nut using 7/16" wrenches
INSTALL POWDER MEASURE
Wipe down powder tube and disks with anti static dryer sheet
Orient the flat side to the drop tube
Adjust the lever above the chain hole over the lever below
ADJUST POWDER CHAIN
Push handle up
Feed chain, pull lever down slightly, pull chain one additional bead